Filter
Top Products
22 ASSEM
BLY
A. Reflector
B. License Plate Holder
C. C
ap Nut (D = 5)
•
Install the license plate holder on the license
plate bracket with the bolts (D = 6, L = 14)(3)
and plated cap nuts (3) and tighten them. The
remaining fasteners are used for the license
plate.
A. License Plate Holder
B. Bolt (D = 6, L = 14)
C. Cap Nut
D. License Plate Bracket
Other than US, CN, and AUS Models
only
•
Install the license plate holder on the license
plate bracket with the bolts (D = 6, L = 14)(3)
and plated cap nuts (3) and tighten them. The
remaining fasteners are used for the license
plate.
A. License Plate Holder
B.Bolt(D=6,L=14)
C. C
ap Nut
D. License Plate Bracket
Left Saddlebag
NOTE
żInstall the saddlebags after the “Final Gear
Case Oil”, “Rear Brake Fluid”, and “Rear
Shock Absorber” sections in the Preparation
chapter.
Left Saddlebag Lid Lock Installation
NOTE
żAfter the saddlebag is installed, you can install
the left saddlebag lid lock.
•
Inspect the saddlebags for damage.
•
Insert the ignition key into the lock, and turn
the key counterclockwise to the unlocked po-
sition (hook faces left).
•
With the locked-position mark on the lock fac-
ing up (toward the handle), insert the hook
of the lock, then the lock into the hole in the
left saddlebag lid, and push it straight ahead
so that the projections on the lock fit into the
notches