Filter
Top Products
36 PREPA
RATION
A. Oil Filler Cap
B. O
il Level Sight Gauge
C. H (High) Level Line
D. L (Low) Level Line
•
If the oil level is too high, remove the excess
oil through the oil filler opening, using a sy-
ringe or some other suitable device.
•
If the oil level is too low, add oil to reach the
correct level. Use the same type of oil that is
already in the engine.
•
When replacing the cap, be sure the O-ring is
in place, and tighten the cap.
Recommended Engine Oil
Type:
API SE, SF or SG
APISHorSJwithJASOMA
Viscosity:
SAE 10W-40
Capacity: 2.9 L (3.1 US qt)
[when filter is not removed]
3.1 L (3.3 US qt)
[when filter is removed]
Although 10W-40 engine oil is the recom-
mended oil for most conditions, the oil viscosity
may need to be changed to accommodate
atmospheric conditions in your riding area.
Final Gear Case Oil
Final G
ear Case Oil Level Inspection
•
Have a helper hold the motorcycle vertical on
level ground.
•
Remove
the filler cap.
•
Check the oil level. If it is low, add oil as
necessary. The oil level should come to the
botto
m thread of the filler opening with the
motorcycle held vertical on level ground.
A. Bottom Thread
B. Filler Cap
•
If the oil level is too low, add the specified oil.
•
If the oil level is too high, remove the excess
oil, using a syringe or some other suitable
device.
WARNING
Be careful that no oil gets on the tire, rim,
and brake disc. Clean off any oil that
inadvertently gets on them with oilless
solvent.
CAUTION
Be careful not to allow any dirt or foreign
materials to enter the gear case.
NOTE
żUse the same type of oil that is already in the
final gear case.