Filter
Top Products
16 ASSEM
BLY
Helmet Locks
•
Unlock the helmet lock with the key and fit
the small projection of the lock into the hole
in the bracket of each rear guard and fasten
it with the screw (D = 5, L = 12) having a
non-permanent locking agent.
•
Lock the helmet lock.
A. Helmet Lock
B. Ignition Key
C. Projection
D. Screw
E. Rear Guard (Left)
Rear Guards (Left and R ight)
Rear Guards Installation
•
Remove the right saddlebag.
•
Insert the ignition key into the lock and turn
the key counter clockwise and pull the knob
outward to open the lid.
A. Saddlebag (Right)
B. Ignition Key
C. Counterclockwise
D. Knob
•
Open the saddlebag lid and remove the bolts
(D = 8, L = 75) inside the saddlebag, and then
pull it up.
A. Bolts (D = 8, L = 75)
•
Join the rear left guard end and the left sad-
dlebag/muffler bracket with the bolts (D = 8, L
= 35)(2) and cap nuts (2) and tighten them.
•
Install the guard on the brackets with the up-
per bolt (D = 10, L = 30) and the lower socket
bolt (D = 10, L = 50) and tighten them.
A. Rear Guard (Left)
B. Bolts (D = 8, L = 35) and Cap Nuts
C. Bolt (D = 10, L = 30)
D. Socket Bolt (D = 10, L = 50)
•
Push the large plastic plug into the top of the
socket bolt.
A. Plastic Plug
B. Rear Guard (Left)
•
Install the right guard in the same manner as
the left guard.