Filter
Top Products
ASSEMBL
Y23
A. Lock
B. Left Saddlebag
C. L
ocked-position Mark
D. Projections
E. Notches
NOTE
żPush the lid lock all the way into the hole in
the lid so that the projection ends are inserted
into it.
A. Lock
•
Turn the key clockwise and counterclockwise,
to check the saddlebag lid lock operation.
Left Saddlebag Dampers Installation
•
Insert the large dampers (2) so that the
grooves fit into the holes in the lower brack-
ets of the left saddlebag/muffler bracket.
A. Dampers
•
Open the saddlebag lid, and insert the upper
dampers (2) into the holes in the saddlebag.
•
Push the f langed collars (2) into the damper.
A. Upper Damper
B. Collars
Left Saddlebag Installation
NOTE
żOnly use the flat washers (T = 1.6 mm) (4)
to adjust the clearance [1.0 mm (0.04 in.) or
more] between the saddlebag upper dampers
and the bracket, as needed.
•
While aligning the protrusions on the bottom
of the saddlebag with the holes in the lower
bracket, engage the hook on the back of the
saddlebag with the upper bracket, then push
it down.
A. Saddlebag
B. Protrusion
C. Hook
D. Upper Bracket