Filter
Top Products
52
Introduction to Navigation
NOTE: Only one waypoint can have either a target or a grid applied to it at one
time. If you apply a target or a grid to a new waypoint, the original waypoint will
lose its target or grid.
NOTE: The spacing of the rings on the waypoint target and the spacing of the
grid lines on the trolling grid are the same as the length of the scale bar on the
left edge of the display. Zooming in or out will decrease or increase the spacing,
respectively.
Save, Edit or Delete a Route
Save the current route: While you are navigating, the current route can be
saved. From the Navigation X-Press™ Menu, select Save Current Route, and
press the RIGHT Cursor key. Navigation will continue.
Create a route: From the Routes submenu, select Create and press the
RIGHT Cursor key. A Route Edit dialog box will be displayed with an empty
route. You can name the route, add waypoints to the route from the saved
waypoints list, and order the waypoints in the route using the 4-WAY Cursor
Control key to move between fields.
Edit a saved route: From the Routes submenu, select Edit and press the
RIGHT Cursor key. A Route Edit dialog box will be displayed. Select the route
you want to edit and press the RIGHT Cursor key. Re-name the route or
change, delete, or re-order the waypoints used in the route.
Edit waypoint order in a route: From the Route Edit dialog box, highlight a
waypoint in the In Route list, and press the RIGHT Cursor key to access the
Waypoint In Route submenu. From this submenu, you can move the
waypoint up or down in the route order or delete it from the list.
Delete a saved route: From the Routes submenu, select Delete and press
the RIGHT Cursor key. Select the route you want to delete and press the
RIGHT Cursor key. You will be asked to confirm your choice by pressing the
RIGHT Cursor key again before the route is deleted.
Travel a saved route: From the Routes submenu, select Travel, and press the
RIGHT Cursor key. The saved routes list will appear. Select the route you
want to travel, and press the RIGHT Cursor key to make this route the current
route and begin navigation. You may also travel the route in forward or
reverse order by changing the Direction setting in the saved routes list.
Route Info: From the Routes submenu, select Info, and press the RIGHT
Cursor key. The saved routes list will appear. Select a route, and press the
RIGHT Cursor key. The following information will be displayed for the route
you select: The waypoints in the route, with the distance and bearing from
each waypoint to the next, as well as the distance and bearing from the
current position to the first waypoint in the route.
Display the Routes submenu: From any view, press the MENU key twice
to display the Main Menu, then press the RIGHT Cursor key to select the
Navigation tab. Press the DOWN Cursor key until Routes is highlighted,
and press the RIGHT Cursor key to display the Routes submenu.