Filter
Top Products
Proximity wpt locked - At least one proximity waypoint is locked because the way-
point has been removed from the Jeppesen NavData®, the
data card is missing, or the data card has failed.
Proximity wpt moved - One or more proximity waypoints were moved at least 0.33
arc minutes due to a database change.
Proximty wpt deleted - One or more proximity waypoints were deleted while receiv-
ing data from the PC 150 Interface Kit.
Pwr down and re-init - The GPS 150 is unusable until power has been cycled and the
unit re-initialized. Abnormal satellite conditions may exist.
RAM failed - The GPS 150 has detected a failure in its internal memory. If
the message persists, the GPS 150 is unusable and should be
taken to an authorized GARMIN service center.
Ready for navigation - The GPS 150 is ready for navigation.
Received invalid wpt - A waypoint was received in an upload operation that has an
invalid identifier or position.
Receiver failed - The GPS 150 has detected a failure in the receiver hardware.
If the message persists, the GPS 150 is unusable and should
be taken to an authorized GARMIN service center.
ROM failed - The GPS 150 has detected a failure in its permanent memo-
ry. If this message occurs, the unit is unusable and should be
taken to an authorized GARMIN service center.
Route is empty - An attempt has been made to activate an empty route.
Route is full - An attempt has been made to add more than 31 waypoints
to a route. The GPS 150 will not allow more than 31 way-
points per route.
Route wpt deleted - One or more route waypoints were deleted while receiving
data from the optional PC150 Interface Kit.
Route wpt locked - At least one route waypoint is locked because the waypoint
has been removed from the Jeppesen NavData®, the data
card is missing, or the data card has failed.
74
APPENDIX C
GPS 150 Messages
150man rev E 7/24/98 3:11 PM Page 74