Filter
Top Products
Appendix B
Installation, Removal and Maintenance of the GPS 150
The aviation rack is designed to allow easy removal of the GPS 150. This enables
you to use the unit at home to create routes, interface to a PC, etc.
To install the GPS 150 into the aviation rack:
1. Insert a 3/32” allen wrench in the small hole adjacent to the dual knob.
2. Rotate the wrench counterclockwise until it stops to ensure the pawl latch is in the
proper position.
3. Insert the GPS 150 into the aviation rack and rotate the wrench clockwise to secure the unit.
To ensure proper connector seating, gently press on the left side of the unit until tightened.
To remove the GPS 150 from the aviation rack:
1. Insert a 3/32” allen wrench into the small hole adjacent to the dual knob.
2. Rotate the wrench counterclockwise until the GPS 150 can be removed from the rack.
69
APPENDIX B
Installing and Removing
the GPS150
150man rev E 7/24/98 3:11 PM Page 69