Filter
Top Products
To change the Input/Output settings (channel 1 or channel 2):
1. Press
S
and rotate
O
until the I/O Channel 1 (or 2) page is displayed.
2. Press
C
and rotate
O
to select the field you would like to change.
3. Rotate
K
to select the proper setting.
4. Rotate
O
to highlight another, or
C
to complete.
5. To use the PC 150 interface kit, the GPS 150 channel 2 settings must be:
in: off, out: plotting. Set the baud rate to 9600. Press
C
to complete.
Channel 2 Setup for use with the PC 150 interface kit.
The GPS 150 can also output data to EFIS and other ARINC 429 devices used for
navigation. The unit may be configured to output the data with or without GAMA
labels. GAMA labels are required if the device uses route specific information such as
identifiers, location, etc., or to use the nearest waypoint information.
To set the ARINC 429 output:
1. Press
S
and rotate
O
until the ARINC 429 Output page is displayed.
2. Press
C
and rotate
K
to change to ‘off’, ‘with GAMA labels’, or ‘w/o GAMA labels’.
3. Press
C
to complete.
62
REFERENCE
I/O Channel Settings &
ARINC 429 Output
Section
5
I/O Channel 1 page
I/O Channel 1 page
ARINC 429 Output page
150man rev E 7/24/98 3:11 PM Page 62