Filter
Top Products
43
Reference
The Setup Page
You can choose from eight time
zones plus ‘other’.
7. If you selected ‘NO’—and you are tracking satel-
lites, you will be asked ‘DO YOU WANT TO USE CUR-
RENT GPS ALTITUDE’? If you do highlight ‘YES’ and
press ENTER. A message ‘CALIBRATION COMPLETED
SUCCESSFULLY’ will be displayed. Highlight ‘OK’ and
press ENTER. If you don’t highlight ‘NO’ and press
ENTER. You will be prompted that ‘YOU DO NOT
HAVE ENOUGH INFORMATION’ and referred to this
manual. Highlight ‘OK’ and press ENTER to return to
the MENU Page.
Setup Page
The Setup Page allows you to customize the eTrex
Summit. On the Setup Page you can change coordinate
systems, map datums, and distance units. You can also
change the time format, north reference, operating mode,
display contrast, and display back light timeout.
Time Format
The Time Page allows you to select a 12 hour or 24
hour time format, enter the proper time zone, and choose
Daylight Savings Time. When you select 12 hour time
formatting, the clock will read like a standard clock with
12 hour AM and 12 hour PM cycles. The 24 hour option
sets the eTrex Summit to display a 24 hour cycle (Military
Time).
To change the time format:
1. Press the PAGE Button and switch to the MENU
Page. Press the UP or DOWN Button and highlight
‘SETUP’. Press ENTER. The SETUP Page appears.
2. Press the UP or DOWN Button and highlight ‘TIME’
and press ENTER.
3. Press the UP or DOWN Button and select the ‘TIME
FORMAT’ fi eld and press ENTER.
4. Press the UP or DOWN Button, select 12 or 24 hours
and press ENTER. Press PAGE to get back to the
page of your choice.
Calibration
190-00193-00_0D.indd 02/12/01, 10:09 AM43