Filter
Top Products
Remote Programming Routine CM6000
CM6000 Install Guide
Alarm and Starter System
www.firstechonline.com | www.compustar.com
Copyright 2009 Firstech, LLC.
Page 6
IMPORTANT: Any and all remotes must be coded to the control module prior to performing any and all opera-
tions.
Remotes excluding 2WSSR-Pro
STEP 1: Activate programming mode by manually turning the vehicle’s key between the Ign On and Off (or the
Acc & On positions) ve times within 7 seconds. The vehicle’s parking lights will ash once with the successful
completion of this step. (Note: this step also places the control module into Valet Mode)
STEP 2: Within a 2 second period after the 5th ignition cycle tap Button I on two way remotes or the Lock but-
ton on one-way remotes for 0.5 seconds. The parking lights will ash once to conrm the transmitter has been
coded. Repeat for additional remotes, up to three.
Exiting Programming: Programming is a timed sequence. After 2 seconds the
parking lights will ash twice signaling the end of programming mode.
Programming Multiple Remotes: After the conrmation ash given in STEP
2, code additional remotes by tapping Button I on two way remotes or the
Lock button on one way remotes. The parking lights will ash once con-
rming each additional remote. All systems (except the PWSSR-Pro), can
recognize up to three remotes.
Note: If you do not program any remotes and enter this sequence it will put
the system into Valet Mode. Only the keyless entry will work in Valet Mode.
To exit Valet Mode just program remote(s).
2WSSR-Pro
STEP 1: Remove the AA battery from the remote.
STEP 2: Activate programming mode by manually turning the vehicle’s key between the Ign On and Off (or the
Acc & On positions) ve times within 7 seconds. The vehicle’s parking lights will ash once with the successful
completion of this step. (Note: this step also places the control module into Valet Mode)
STEP 3: Within a 2 second period after the 5th ignition cycle, insert the AA battery into the remote. The park-
ing lights will ash once to conrm this step. If you have an additional 1 W
ay remote tap the Lock button after
inserting the AA battery into the 2 Way remote.
STEP 4: Wait several seconds for the parking lights to ash twice and the remote LCD to receive a page back.
The transmitter has now been coded.
Programming Multiple Remotes: After the conrmation ash in step 3, program the optional 1 Way remote
by tapping the Lock button for 0.5 seconds. The parking lights will ash once conrming that the 1 Way this
remote has been learned. The 2WSSR-Pro can recognize (1) 2 Way remote and (1) 1 Way remote.