Filter
Top Products
CM6000 Install Guide
Alarm and Starter System
www.firstechonline.com | www.compustar.com
Copyright 2009 Firstech, LLC.
Page 23
1-04 Double Pulse Unlock - If enabled, this option will cause the system to double pulse the unlock output.
This option is used on a majority of Toyota vehicles. The rst unlock pulse disarms the alarm, and the
second pulse unlocks the doors.
1-05 Rearm Output - These optional settings change the event trigger on the orange rearm wire.
1-06 Reservation Lock - Manual transmission only. Setting III will provide a 10 second delay before the
vehicle shuts off after closing the last door to allow for another door to open. Upon a door opening, the
user will have 2 minutes to close the last door in order for reservation mode to set.
1-07 Unlock / Disarm with Trunk Release - This option sets that the unlock and/or factory disarm wires do
during remote trunk release. The options are pretty self explanatory.
1-08 Passive Mode - This option comes with default off. This feature controls what the lock wire does during
passive mode.
1-09 Ignition Controlled Locks - Setting 2 will lock the doors when the foot brake is pressed and doors
closed. Tach sensing mode must be used for setting 3. You must also turn this feature on through the
remote by tapping I+IV (2 Way remotes) or Lock+Key (1 Way remotes).
1-10 Auto Relock – This option will automatically relock/rearm after the system has been disarmed and the
doors have not been opened.
1-11 Ignition / Accessory Upon Unlock – This option will pulse the ignition wire, accessory, or both upon
unlock/disarm. Most new Chrysler vehicles need the ignition and accessory pulsed to disarm the factory
alarm.
1-13 Double pulse disarm - This feature changes the behavior of the small orange/white disarm wire. When
the feature is turned on it will change the default single pulse to double pulse upon disarm/unlock.
1-14 Auto Mode - This option turns the auto lock/arm and unlock/disarm feature on. This is only available
with international 2-Way remotes. The user must also turn this feature on with the remote by holding
button1 for 2.5 seconds. This mode will automatically lock/arm and unlock/disarm when the user leaves
or enter the range of the vehicle.
1-15 Trunk Output Timing - This option changes the time of the output pulse on the violet/white wire during
trunk release. The default setting is 1 second. With the two options you can shorten to lengthen the out
put by minimum of 0.5 seconds to a maximum of 2 seconds.