Filter
Top Products
CM6000 Install Guide
Alarm and Starter System
www.firstechonline.com | www.compustar.com
Copyright 2009 Firstech, LLC.
Page 32
Troubleshooting CM6000
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will ash three times immediately. Following those
three ashes the parking lights will ash again corresponding to the error table below:
Number of
Parking Light
Flashes
Remote Start Error
1
Motor running or must program tach before 1st
remote start
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8 Tach or no tach sensing failure
*Pro 2 Way remotes will display the error number “Strt Er##” on the LCD.
Alarm LED Diagnostics
When the alarm is triggered the LED on the RPS (if installed), Secure Valet (if installed) and the LED (if in-
stalled) will ash a certain amount of times as shown in the table below.
This is intended for users with 1 Way
remotes.
Priority Trigger LED Flash Diagnostic
1 Door/Hood/Trunk/Ign Triggered 2 ashes, break, then repeat
2 2nd Shock Triggered 3 ashes, break, then repeat
3 2nd Auxiliary Input Triggered 4 ashes, break, then repeat
4 Panic with remote 5 ashes, break, then repeat
Frequently Asked Questions
I have everything hooked up and the system will not respond.
A: The remotes need to be programmed. Review the “Common Procedure” section of this manual.
Frequently Asked Questions CM6000