Filter
Top Products
CM6000 Install Guide
Alarm and Starter System
www.firstechonline.com | www.compustar.com
Copyright 2009 Firstech, LLC.
Page 28
4-08 Extended Accessory After Ignition Shutoff – This option keeps the Accessory wire powered up after the
ignition is shut off. This can be used to keep the radio turned on even after the key is removed from the
ignition (similar to GM vehicles).
4-09 Glow Plug or Key Sense – Default setting sets the wire as a glow plug input. Option setting 2 changes
the wire to a key sense input. Key sense can be used to prevent reservation mode from setting and the
system from passive arming while the key is still in the ignition. Key sense also turns off dome-light
supervision when the key is inserted into the ignition.
4-10 Trigger Start or Closed Loop System – Default setting sets the pink wire on CN3 as a trigger start
input, which will initiate remote start with a negative (-) trigger. Option 2-04 allows the number of
pulses required to initiate remote start to be changed. Setting 2 changes the wire to a closed loop
input, which makes it an instant alarm trigger when separated from ground - Ideal for protecting
trailers or headlights.
4-11 Bypass Brand Through RS232 Port – Default setting allows for compatibility with ADS Idatalink
modules. Setting 2 changes compatibility to Fortin bypass modules.
4-13 Antenna Power Save - Some people may not drive their vehicle very often, this may cause the battery
to become discharged because it is not getting recharged on a regular basis. The antenna power save
option will turn off the antenna after the specied amount of time to conserve power. While the antenna
is asleep, the system will not respond to the remotes. Any type of input to the system will wake up the
antenna, i.e.: ignition, brake, door, trunk, hood, shock, rps, ect. This means that a remote start only user
just needs to open their door to reactivate the system, however, a user with an alarm or alarm/start
system will need to trigger the prewar stage of the shock sensor to quietly wake up the antenna.
4-14 Low Battery Warning - This feature option which is default to off. When the system is armed and the
feature is on the main control unit will monitor the voltage of the vehicles battery at its connection point.
When the battery voltage drops to or below 11 volts the control module will send a page to the 2way. It
will beep several times for 5 seconds, every 50 seconds, 3 times and ash the battery indicator on the
remote. When you query the remote or unlock/disarm the system the remote will display the voltage of
the vehicle’s battery.