Filter
Top Products
34 Installing System Components
Standard Hard-Drive Carrier
Use a standard hard-drive carrier to install 3.5-inch SAS/SATA/SSD hard-
drive into the sled.
Removing a Standard Hard-Drive Carrier
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION: To maintain proper system cooling, all empty hard-drive slots must
have hard-drive blanks installed.
CAUTION: Use only hard-drives that have been tested and approved for use with
the hard-drive backplane.
CAUTION: To prevent data loss, ensure that your operating system supports hot-
swappable drive installation. See the documentation supplied with the operating
system.
NOTE:
Only SAS hard-drives are supported in a dual-cable SAS expander
connection.
1
Open the sled. See "Opening the Sled" on page 28.
2
Using the strap handle, pull the standard hard-drive carrier out of the drive
bay. See Figure 2-6.