Filter
Top Products
Installation Guide P. 27
transmitter, and to unlock the other doors, if desired, by pressing the UNLOCK button for a second
time.
The output will provide a 1-second negative output when the
UNLOCK button is pressed a second
time on the transmitter. This can be used not only as priority door access, but also as trunk
release.
¾ Horn Confirmation:
AUX 1 can be programmed to trigger the horn every time the LOCK button is pressed, or when the
LOCK button is pressed twice within 3 seconds. When horn confirmation is activated, panic mode is
enabled. If horn confirmation is disabled, panic mode will not be available.
The AUX 2 Timed Output
This 500 mA negative AUX 2 output can be used for many different applications. It can be
programmed for priority door access if
AUX 1 is programmed for horn confirmation. For additional
information, please refer to the “3-pin Harness” section earlier in this Guide.
The AUX 3 / Trunk or Sunroof Output
This 500 mA negative AUX 3 output can be used for many different applications. The output can be
programmed to give a 1-second pulse when the
TRUNK button is pressed (if the ignition is OFF or
during a remote start), or to give a continuous output as long as the
TRUNK button is held down (for
sunroof or window control).
If the Option 3 is selected, a disarm pulse will be sent before the trunk is popped. An arm pulse will
be sent 4 seconds later. This option is overridden when the Zone 3 option is used as a trunk pin
(Menu 3, Feature 5, Option 1).
Programmable External Trigger
For additional information, please refer to the “12-pin Accessories Harness” section earlier in this
Guide.
OEM-Style Alarm
The OEM-style alarm (if configured) monitors the doors, hood and ignition switch of the vehicle. It
will sound the horn if a door or the hood is opened, or if the key is turned in the ignition (the horn
option must be enabled and one of the door inputs must be connected).
• To arm the OEM-style alarm, press the LOCK button on the transmitter.
- The OEM-style alarm will ONLY arm if the LOCK button on the transmitter is pressed.
- The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now
armed.
• To disarm the OEM-style alarm, press the UNLOCK button on the transmitter.
- To stop the horn from sounding if the OEM-style alarm is triggered, press the LOCK or
UNLOCK button, or put the system in and out of Valet Mode.
Ready Mode Option
If the vehicle has a manual transmission, please read the following indications. In order to start
the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected. Therefore, you must follow the appropriate procedure between
the two described below in order to set the vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN)
position.