Filter
Top Products
Installation Guide P. 15
compatibility and functionalities).
5
Pager Port
Is used to connect an optional AS-200P pager (to use this option, make sure to program
pager option in Menu 3, Feature 5, Option 4).
Entering Programming Mode
This allows the installer to program the unit. Once the system is in programming mode, the installer
will have up to 20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu
before the 20-second delay, the system will exit programming mode and the installer will have to
select again one of the 2 methods to get access to it.
Using the Hood Pin
Using the Antenna Programming Assistance
Button (A.P.A.B.)
• Press and hold the hood pin for 4 seconds. • Make sure that the hood is closed.
• Release the hood pin.
The parking lights will turn
ON.
• Turn the ignition key to the
IGNITION ON (RUN)
position.
• While the parking lights are ON, press the hood
pin once more and release immediately.
The parking lights will turn
ON and stay ON for
20 seconds.
• Within 5 seconds, press the programming button
on the antenna twice for 1 second each time.
The LED will come
ON solid.
• You now have 20 seconds to select one of the
sub-menus.
• You now have 20 seconds to select one of the
sub-menus.
Note: To exit programming mode, close the hood.
Note: To exit programming mode, press on the
antenna button once (the LED will come ON) and
release.
Remember: You can use the programming Assistance button instead of the
hood pin at any time the hood is up.
The Programming Assistance Button (a.k.a. PAB)
The PAB is located
on the side of the
module. This push
button mimics the
hood-pin switch in
order to avoid having
to get out of the
vehicle and pressing
the hood-pin switch.
The PAB will work
only when the hood
is up.
Once inside the programming options, the installer has a selection of many different sub-menus:
a) Transmitter Programming
b) Programming Options
c) Honk Horn Timing* (*if available)
d) Tach Programming