Filter
Top Products
Installation Guide P. 19
Multi-speed Tach Programming
1. Enter programming mode (see on page 15) the parking lights will stay on for up to 20
seconds.
2. Before the lights go out, press and hold the brake pedal and press the LOCK and UNLOCK
buttons simultaneously the parking lights will flash 4 times. At that point, release the brake
pedal.
3. Start up the engine and allow the vehicle to reach regular engine idle speed.
4. Once the engine is running at normal idle speed, press the brake pedal and keep it down until
you hear the parking lights output click 5 times.
5. Release the brake pedal the tach programming is now complete.
Other Features of the Module
Fifth Relay Output (2nd IGN, ACC or CRANK)
Remote car starters of this series are equipped with an
on-board high-current programmable 5
th
relay that can be
used to power a second ignition, accessory or crank wire.
The unit uses 3 sets of pins; each set corresponds to a
specific function of the output. In order to activate one of
the three possible functions, you must place the jumper
(supplied) on one of the three sets of pins and connect the
14 AWG wire to the second
IGN. / ACC. / CRANK wire of
the vehicle.
Caution!
Only one set of pins can be used at one time. Using more than one jumper may result in serious
damage to the vehicle. The relay output rating on this unit is 25a at most. Defective oem solenoid
switches can sometimes draw up to 50 or 60a, causing the 30a fuse to blow. Always verify your
circuit with an appropriate measuring device.
Tach jumper settings
Some new vehicles have a higher TACH voltage
threshold, which would fall out of the normal
TACH trigger circuit of the remote car starter.
Changing the jumper to TACH Threshold HIGH
will allow the module to properly detect the TACH
signal.