Filter
Top Products
Installation Guide P. 23
Flashing LED
To gain access to this feature, make sure the Flashing LED option has been enabled at the time of
programming. Once this option is enabled, the user has the choice to toggle the Flashing LED
ON
and
OFF at any given moment.
To toggle between the Flashing LED
ON and OFF, press LOCK and TRUNK simultaneously on the
Transmitter. The parking lights will flash once slowly to indicate that the LED is active. If you press
LOCK and TRUNK once more, the parking lights will flash 3 times quickly to show that the LED is
now disabled.
• Flashing LED ON: The LED will flash at all times (being passive or active arming) to denote
that the Starter Kill is active.
¾ Active arming: the LED flashes normally.
¾ Passive arming: the LED will flash at a faster rate during the countdown until the Unit
is armed, at which time the flashing rate will slow down.
¾ In Valet Mode: the LED will be on solid.
• Flashing LED OFF: The LED will not flash when the module is armed (passive or active
arming). However, if the module is in Valet Mode, the LED will remain
on solid when the Ignition is OFF.
Safe Start
If this feature is enabled, the user must press the START button twice within 3 seconds to remote-
start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing with the
transmitter.
• To remote-start the vehicle if Swap Start Mode is selected, press LOCK and UNLOCK
simultaneously.
• The AUX 2 output can be activated by pressing the START button. The Option 1 or 2 must
have been configured in Menu 3, Feature 3 (AUX 2).
Engine Run Time
On a gas engine, the Remote Car Starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). On a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes by default).
Idle Mode
Convenience feature: Idle Mode allows the user to keep the engine running and the doors
locked while they stop, for example, at a convenience store or for a short delivery.
This feature allows the user to let the remote starter take over control of the vehicle (i.e. no Key in
the Ignition Switch) while the engine is running.
If the vehicle has an automatic transmission, proceed as follows to set the system to Idle
Mode:
1. With the engine running, make sure to release the brake pedal and press the LOCK, UNLOCK
or START button on the transmitter until the parking lights come ON.
2. Remove the ignition key from the ignition switch.
The engine will continue running.
3. Exit the vehicle and close all doors, hood and trunk.
4. Press the LOCK button to leave the doors locked.
This will also arm the OEM-style alarm and starter kill (if configured).
5. Press the UNLOCK button to leave the doors unlocked.
Note: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.