Filter
Top Products
64
motorways for pedestrians), or some of the restrictions may not be taken into account
(e.g. emergency vehicles have no restrictions). Available values:
• Car
• Taxi
• Bus
• Lorry
• Emergency
• Bicycle
• Pedestrian
5.4.4 Road types to include/exclude
To let the route fit your needs you can also set which road types are to be considered
for or to be excluded from the route if possible. When a road type is selected, its
lamp is green, if not, it turns red and is crossed-out as already described in 3.2.5.
Note: Excluding a route is a preference. It does not necessarily mean total
prohibition. If your destination can only be accessed using some of the excluded road
types, Touch & Go Navigator will use them but only as much as necessary. In this
case a warning icon will be shown on the Route Information screen (4.6), and the
road not matching your preference will be displayed in red (yellow at night) on the
map.
5.4.4.1 Unpaved Roads
Unpaved roads are excluded by default, as they can be in a bad condition and you
usually cannot reach the speed limit on them.
5.4.4.2 Motorways
When driving a slow car or towing another vehicle, you may prefer not to take
motorways. In this case change the default green to red.
5.4.4.3 Ferries
The accessibility of temporary ferries is not necessarily included in the map data.
Furthermore you may need to pay fare, so you may consider disabling them from the
preset enabled status.
5.4.4.4 U-turns
Although displayed amongst road types, this is a type of action. Most drivers prefer to
replace them with a few normal left and/or right turns in the next few junctions, so it is
disabled by default.
Turning back on dual carriageways is not considered as a u-turn.