Filter
Top Products
37
Tip: If you want to see the map around the Cursor, close the Cursor menu and
reopen it. When this menu is opened manually, the map is always moved to have the
cursor in the centre.
The content of the Cursor menu depends on the screen (Map or Cockpit) and it is
slightly different if there is an active route already planned. You have the following
options:
• Start: use the Cursor as the departure point for your route. This menu point is
available only in Map mode and when there is no active route. In Cockpit
mode the departure point of the route is always the GPS position or if it is not
available, the last known GPS position.
• Route To: use the Cursor as the destination of your route. This button is to
start a new route. The previous route (if it exists) will be deleted and replaced.
If a multi-point route is active, Touch & Go Navigator will ask you whether you
really want to delete it together with all its via points.
• Add Via: by inserting the selected map point as a via, you instruct Touch & Go
Navigator to cross this location before the destination of the route. This is the
way to build a multi-point route in reverse order (when you wish to insert a
stopover ‘go to A but first get some fuel at B’ or want to influence the direction
of the route). This menu point works only if a route is already active.
• Remove Via
: removes the ‘via point’ near or at the Cursor. The route will be
recalculated immediately excluding the deleted point. This menu point
replaces Add Via and is available only if the Cursor is near or at a via point.
• Continue: add a new destination to be reached after the previous destination.
The new destination replaces the old one, which is now demoted to a via
point. This is the way to build your multi-point route in straight order (when you
wish to visit several destinations ‘go to A then to B’). This menu point is
available only if a route is already active.
• Pin
: push a coloured pin in the map at the selected point for later use. This pin
is visible at all zoom levels and also appears in the History list together with its
exact position. The colour of the pin is automatically selected by Touch & Go
Navigator.
• Unpin
: remove the pin near or at the Cursor. This menu point replaces Pin
and is available only if the selected point is near or at a pin.