Filter
Top Products
59
5.1.5 Off-route Recalculation
Once a route is planned, this setting will tell Touch & Go Navigator what to do when
you deviate from that route.
5.1.5.1 Automatic
The route will be recalculated automatically a few seconds after you go astray.
5.1.5.2 Ask First
Touch & Go Navigator can also ask your preference each time you leave the planned
route. The route will not be recalculated until you make your choice from the menu
that automatically appears (also explained in 4.6.2).
Your options are:
• Recalculate: Touch & Go Navigator will recalculate the route with the previous
settings. The result is the same as if Automatic recalculation was selected.
• Drop Next Via Point / Delete Route: Touch & Go Navigator will remove the
next via point from the list and recalculate the route without it. If you have only
one target left, the label of the button will be Delete Route, and it will end
navigation.
• Bypass: if you have deviated from the original route because of a traffic jam or
roadworks, you can instruct Touch & Go Navigator to avoid the original route
for a specified distance.
• Cancel: you can exit without recalculating the route. Navigation stops and will
be activated again when you find your way back to the original route.
5.1.5.3 Disabled
If you stick to the original route, and you wish to get back to it on your own, you can
disable recalculation. This way guidance will stop until you return to the
recommended route.