Filter
Top Products
2 - 41
SPEC
CABLE ROUTING
1 Rear brake light switch lead
2 Negative battery lead
3 Lean angle cut-off switch lead
4 Throttle position sensor lead
5 Coolant temperature sensor lead
6 Turn signal/hazard relay
7 Headlight relay
8 Radiator fan motor relay
9 Relay unit
È Fasten the wire harness, negative battery lead,
and rear brake light switch lead to the frame with
a plastic locking tie.
É Fasten the rear brake light switch lead to the
frame with a plastic locking tie.
Ê Fasten the wire harness to the frame at the
white tape with a plastic locking tie.
Ë Route the negative battery lead behind the lean
angle cut-off switch bracket.
Ì Route the rear brake light switch lead between
the air filter case and the frame.
9
8
7
6
Ì
È 1 ÈÉ2 Ê 345
Ë
É