Filter
Top Products
1 - 7
GEN
INFO
SPECIAL TOOLS
EAS00027
SPECIAL TOOLS
The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No. Tool name/Function Illustration
Slide hammer bolt
90890-01083
Weight
90890-01084
Slide hammer bolt
Weight
These tools are used to remove or install
the rocker arm shafts.
90890-01135
Crankcase separating tool
This tool is used to remove the crank-
shaft.
Attachment
90890-01243
Compressor
90890-04019
Valve spring compressor attachment
Valve spring compressor
These tools are used to remove or install
the valve assemblies.
90890-01268
Ring nut wrench
This tool is used to loosen or tighten the
steering ring nuts.
Pot
90890-01274
Bolt
90890-01275
Crankshaft installer pot
Crankshaft installer bolt
These tools are used to install the crank-
shaft.
90890-01304
Piston pin puller set
This tool is used to remove the piston pin.
90890-01325
Radiator cap tester
This tool is used to check the cooling sys-
tem.