on the Today screen, or the iGO icon in the Start/Programs section of the operating
system to run iGO manually. You will still be able to exit iGO by removing the card.
Creating a multi-point route I have tapped the ‘Route To’ button once for each
destination but only the last one appears in the list, all previous points have
disappeared.
The ‘Route To’ button is for starting a new route only. For a single route you tap this
when the destination is selected. Multi-point routes can be created after you have
established a single route. Add points to the single route by using the ‘Add Via’ and
‘Continue’ buttons. Applying ‘Route To’ again will delete the whole route. In your
case only single routes existed before, so they were deleted without a warning
message. If you already have a multi-point route, iGO warns you before deleting the
whole route. Sometimes the operating system disables the autorun feature. The best
you can do is to soft reset* your PNA . That should restore autorun functionality. If
you choose not to initiate a reset, please look for the iGO 2006 strip on the Today
screen, or the iGO icon in the Start/Programs section of the operating system to run
iGO manually. You will still be able to exit iGO by removing the card.
The speaker icon shows iGO is not muted yet I hear no voice guidance.
The muting available from both map screens is just a quick silencer that cancels the
sound output. Voice guidance and key sounds need to be enabled and volume must
be set at the Sound Settings screen (Page ).59
I enabled the speed warning as soon as I bought the product but I have just
been fined for speeding because iGO failed to warn me.
For an accurate speed warning the actual speed limits of each street and road must
be present correctly on the map. This is a relatively new feature of digital maps, so it
may not be available in some countries, and its accuracy still has much room for
improvement (ask your local dealer for the details in your region). This feature can
help you in several cases but it cannot be considered as serious speed control. That
is why it can be turned on and off separately from the reliable voice guidance (Page
). Sometimes the operating system disables the autorun feature. The best you can
do is to soft reset* your
55
PNA. That should restore autorun functionality. If you choose
not to initiate a reset, please look for the iGO 2006 strip on the Today screen, or the
iGO icon in the Start/Programs section of the operating system to run iGO manually.
You will still be able to exit iGO by removing the card.
I would like to create a new POI during navigation (Cockpit screen) but there is
no Add POI button in the Cursor menu.
For driving safety reasons the Add POI function is only available on the Map screen.
Mark the point with a Pin, and save it as a POI later, when you reach your
destination. If you are not driving, just press the 4th hardware button to switch to
Map mode, where the Add POI button is available. Sometimes the operating system
disables the autorun feature. The best you can do is to soft reset* your PNA . That
should restore autorun functionality. If you choose not to initiate a reset, please look
for the iGO 2006 strip on the Today screen, or the iGO icon in the Start/Programs
section of the operating system to run iGO manually. You will still be able to exit iGO
by removing the card.
86
GNS
GNS GNS
GNS
GNS
GNS
GNS GNS
GNS
GNS
GNS GNS
GNS
GNS
GNS GNS
GNS
GNS