Filter
Top Products
Chapter 5: Installing the ST4000+ 77
5 Installing the ST4000+
Note: You can install the pedestal bracket either way up. In the
standard orientation the pin is at the bottom (below the mounting
holes – see diagram). If obstructions on the pedestal prevent you
from using the standard orientation, you can install the bracket so the
pin is at the top (above the mounting holes).
5. Making sure the slot is central at the bottom of the drive unit
(6 o’clock position) and the pin is in the middle of the slot,
carefully draw around the bracket.
6. Remove the wheel, then hold the bracket on the pedestal in the
location you have marked.
7. Check the position and alignment of the pedestal bracket:
• the bracket pin should be 154 mm (6.1 in) below the pedestal
spindle (see the following diagram)
• the bracket pin should be aligned so it is directly below the
pedestal spindle (see the following diagram)
D5345-2