Filter
Top Products
Chapter 5: Installing the ST4000+ 69
5 Installing the ST4000+
Installing the socket
1. Apply the template (supplied at the rear of this handbook) to the
bulkhead.
2. Carefully drill a 18 mm (
23
/
32
in) clearance hole and two 2.5 mm
(
3
/
32
in) pilot holes. Remove the template.
3. Pass the cable through the bulkhead and attach to the socket,
making sure you connect each core to the correct pin (as shown).
4. Attach the socket to the bulkhead using the two self-tapping
screws. Use cable clamps to secure the drive cable at regular
intervals.
Brown Blue
D3284-2
D383-5
Drive (brown)
2 stripe terminal
Drive (blue)
3 stripe terminal
To the
control unit
Terminal
identification
stripes
Rear of socket