Chapter 5: Installing the ST4000+ 73
5 Installing the ST4000+
4. Align the cover with the wheel drive:
• the two pre-drilled holes (marked with an arrow) must line up
with their matching pair of threaded inserts on the drive ring
(also marked with an arrow)
• make sure that the other spoke clamp holes align with their
threaded inserts
Note: The cover will only fit back onto the wheel drive when you have
aligned the two parts correctly.
5. Fit the cover back onto the wheel drive:
• press the cover in the three places shown on the diagram
below to push each of the posts back into its locating socket
Note: This step is easier with the clutch engaged.
Pre-drilled holes
(marked with arrow)
Pair of threaded inserts
(marked with arrow)
Drive ring
Front cover Drive unit
D5404-1
D5405-1
TOP