Filter
Top Products
User's Guide Destinator 24
Search for a Location
TMC Options
You can tap the Options button The Traffic Information Options dialogue box is displayed, as shown
below.
Figure 27 - Defining Traffic Information Settings
You must configure the Traffic Message Channel (TMC) be defining the following settings:
When an
event occurs:
You can select either:
Automatically - Destinator automatically recalculates the route to avoid a road with
adverse traffic conditions – traffic jam or accident only.
Manual - You can manually select the TMC event from the inbox and tap the Avoid
button from the Show Map screen.
Search for
TMC Stations:
Automatically - Destinator automatically scans the FM radio frequencies until a
TMC station is found. Should you lose the station frequency, Destinator will
automatically scan for a new
TMC station.
Manual - You can use the frequency keys to scan for a TMC station [Not advised].
Test TMC
When you tap this button, Destinator expands the search radius for to the "Whole
Map" for one minute, switches automatically to the
TMC Inbox screen and displays a
test message called "Testing TMC Service". After one minute,
Destinator reverts to
the route and the 200 metre radius.”
If you do not receive a message after tapping this button, please check in the
following sequence:
The TMC receiver is locked on to a TMC station. If not, reconnect your TMC receiver
If you see the tuner scanning but not locking on to a TMC station, try to change your
position and check that your antenna is vertical.
Depending on your location, you might not have TMC coverage.
Check that you are using the map of the country that you are currently travelling in.