Filter
Top Products
User's Guide Destinator 23
Search for a Location
Note: Please go to http://www.tmcforum.com for information about European countries that provide TMC
service. A TMC receiver is required to receive TMC broadcasts.
From the Options menu, select the Traffic Info button, which opens the TMC inbox, and displays traffic
reports. You can select a traffic report and click Next to show a map of the affected road. If you click the
Avoid button, Destinator recalculates your route. Note that if the event was avoided, the Show Map
screen displays the Allow button to recalculate to that previously avoided route section.
Figure 26 - Traffic Info Events
All TMC messages are delivered to the TMC Inbox, but only messages relating the direct route and a 200
metre radius are displayed. The radius is set to 160 kilometres when no route has been selected.
Note: It is strongly recommended that you let Destinator automatically scan and lock onto the TMC
stations and do not manually search for a TMC station.
You can use the following buttons to go to a different radio frequency:
Lets you search for a traffic channel at a lower frequency. When a station is located,
Destinator checks for TMC data. If there is no TMC data for this station, Destinator
continues to scan until a radio station with TMC data is located.
Lets you make minimal (0.1) steps toward a lower frequency to bring in the channel.
Lets you make minimal (0.1) steps toward a higher frequency to bring in the channel.
Lets you scan for a traffic channel with TMC data at a higher frequency.