Nissan 2010 Xterra Automobile User Manual


 
FM/AM/SAT RADIO WITH
COMPACT DISC (CD) CHANGER (if
so equipped)
For all operation precautions, see ЉAudio opera-
tion precautionsЉ earlier in this section.
No satellite radio reception is available when the
RADIObuttonispressedtoaccess satelliteradio
stations unless optional satellite receiver and an-
tenna are installed and an XM satellite radio
service subscription is active. Satellite radio can
only be installed in vehicles that were factory
pre-wired for satellite radio. Satellite radio is not
available in Alaska, Hawaii and Guam.
Audio main operation
POWER/VOLUME control:
Turn the ignition switch to ACC or ON, and then
press the PWR/VOL control knob while the sys-
tem isoff tocall up themode (radioor CD) which
was playing immediately before the system was
turned off.
To turn the systemoff, press the PWR/VOL con-
trol knob.
Turn the PWR/VOL control knob to adjust the
volume.
This vehicle may be equipped with Speed Sen-
sitive Volume (SSV) for audio. The audio volume
changes as the driving speed changes.
AUDIO knob (BASS, MIDRANGE, TREBLE,
FADE, BALANCE and SSV if so equipped):
Press the AUDIO control knob to change the
mode as follows:
BASSMID TREBLEFADEBALANCE
SSV (if so equipped)
Toadjust Bass,Mid (Midrange),Treble,Fade and
Balance, press theAUDIO knob until the desired
mode appears in the display. Turn the Tuning
knob to adjust Bass and Treble to the desired
level. You can also use the Tuning knob to adjust
Fade and Balance modes. Fader adjusts the
sound level between the front and rear speakers
and Balanceadjusts thesound betweenthe right
and left speakers.
To change the SSV mode to OFF, LOW, MID or
HIGH, turn the Tuning knob to the right or left.
Once you have adjusted the sound quality to the
desired level, press the AUDIO knob repeatedly
until the radio or CD display reappears. Other-
wise, the radio or CD display will automatically
reappear after about 10 seconds.
Clock set
1. Press the DISP/CLOCK button until it
beeps (>1.5 seconds).
2. The hours will start flashing. Press the CAT
FOLDER
or button or SEEK
TRACK
or button to adjust the
hours.
3. Press the DISP/CLOCK button again to
switch to the minute adjustment.
4. Press the CAT FOLDER
or
button or SEEK TRACK or
button to adjust the minutes.
5. Press the DISP/CLOCK buttonagain to exit
the clock set mode.
The displaywill returnto the regularclock display
after 7 seconds, or you may press the
DISP/CLOCK button again toreturn to the regu-
lar clock display.
DISP (display) button:
This DISP (display) button will show text about
MP3, SAT or CD informationin the audio display.
4-30 Heater, air conditioner, audio and phone systems