Filter
Top Products
Black plate (287,1)
Model "R35-D" EDITED: 2009/ 3/ 11
5. Remove the wheel nuts and then remove the
wheel.
NOTE:
When putting a wheel on the ground, put it
down with the outer side of the wheel
facing up to prevent scratching of the
wheel surface.
6. Clean any mud or dirt from the surface
between the brake disc rotor
*
1
and wheel
*
2
.
7. Tighten the wheel nuts by hand by turning
them clockwise until the tapered part
*
A
of
each nut lightly contacts the seat part
*
B
of
the wheel hole.
When replacing a front wheel, make sure the
hole in the wheel is aligned with the pin on
the brake disc rotor.
Maintenance and do-it-yourself 8-41