Filter
Top Products
Black plate (141,1)
Model "R35-D" EDITED: 2009/ 3/ 11
gram a garage door opener equipped with
“rolling code protection”; you will need to use
a ladder to get up to the garage door opener
motor to be able to access the “smart or learn”
program button.
1. To begin, push and hold the two outer
HomeLink
®
buttons (to clear the memory)
until the indicator light
*
A
blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held transmitter
1 to 3 inches (26 mm to 76 mm) away from
the HomeLink
®
surface.
3. Using both hands, simultaneously push and
hold both the HomeLink
®
button you want to
program and the hand-held transmitter
button.
DO NOT release the buttons until step 4 has
been completed.
4. Hold down both buttons until the indicator
light on HomeLink
®
flashes, changing from a
“slow blink” to a “rapid blink”. This could
take up to 90 seconds. When the indicator
light blinks rapidly, both buttons may be
released. The rapidly flashing light indicates
successful programming. To activate the
garage door or other programmed device,
push and hold the programmed HomeLink
®
button - releasing when the device begins to
Instruments and controls 2-61