Filter
Top Products
Black plate (263,1)
Model "R35-D" EDITED: 2009/ 3/ 11
1. Remove the cell plugs
*
A
.
2. Add distilled water up to the UPPER LEVEL
*
1
line.
If the side of the battery is not clear, check
the distilled water level by looking directly
above the cell; the condition
*
1
indicates
OK and the conditions
*
2
needs more to
be added.
3. Tighten cell plugs
*
A
.
Vehicles operated in high temperatures or under
severe conditions require frequent checks of the
battery fluid level.
JUMP STARTING
If jump starting is necessary, see the following
section. (
“JUMP STARTING” page 6-4)
If the engine does not start by jump starting, the
battery may have to be replaced. Contact a
GT-R certified NISSAN dealer.
1. Power steering fluid pump
2. Alternator
3. Crankshaft pulley
4. Air conditioner compressor
5. Drive belt auto-tensioner
WARNING
Be sure the ignition switch is in the OFF
or LOCK position before servicing drive
belts. The engine could rotate unex-
pectedly.
1. Visually inspect each belt for signs of
unusual wear, cuts, fraying or looseness. If
the belt is in poor condition or loose, have it
Maintenance and do-it-yourself 8-17
DRIVE BELTS