Filter
Top Products
Black plate (231,1)
Model "R35-D" EDITED: 2009/ 3/ 11
WARNING
Always follow the instructions below.
Failure to do so could result in damage
to the charging system and cause
personal injury.
1. If the booster battery is in another vehicle
*
A
, position the two vehicles (
*
A
and
*
B
)
to bring their batteries into close proximity to
each other. Do not allow the two vehi-
cles to touch.
2. Apply parking brake. Move the shift lever to
the
&
P
position. Switch off all unnecessary
electrical systems (light, heater, air condi-
tioner, etc.).
3. Remove the battery cover. Cover the battery
with a firmly wrung out moist cloth to reduce
explosion hazard.
4. Connect jumper cables in the sequence as
illustrated (
*
1
?
*
2
?
*
3
?
*
4
).
If the battery is disconnected or dis-
charged, the steering wheel will lock
and cannot be turned. Supply power
using jumper cables before pushing
the ig nition switch and disengaging
the steering lock.
CAUTION
. Always connect positive (+) to posi-
tive (+) and negative (−) to body
ground (as illustrated), not to the
battery.
. Make sure that the jumper cables
do not touch moving parts in the
engine compartment and that
clamps do not contact any other
metal.
5. Start the engine of the booster vehicle
*
A
and let it run for a few minutes.
In case of emergency 6-5