Filter
Top Products
Black plate (139,1)
Model "R35-D" EDITED: 2009/ 3/ 11
INTERIOR LIG HT CONTROL SWITCH
The interior light control switch has three
positions: ON
*
1
, DOOR
*
2
and OFF
*
3
.
ON position
When the switch is in the ON position
*
1
, the
map lights will illuminate.
NOTICE
Do no t use the light for extended
periods of time with the engine
stopped. This could result in a dis-
charged battery.
NOTE:
The lights will also turn off after 30
minutes whe n the lights remain illumi-
nated after the ignition switch has been
pushed to the OFF or LOCK position to
prevent the battery from becoming dis-
charged.
DOOR position
When the switch is in the DOOR position
*
2
,
the map lights will turn on when the door is
opened and turn off when the door is closed.
The map lights will turn off approximately 15
seconds after the door is closed with the ignition
switch in the OFF or LOCK position.
NOTE:
When the interior light control switch is in
the DOOR position and the door is open,
the light will remain on even when the map
light switch is pressed to turn off.
Key-linked interior light control system:
The map lights will turn on and off linked with the
locking and unlocking of the door.
This function operates when the interior light
control switch is in the DOOR position.
. When entering the vehicle
When the driver’s seat door is unlocked, the
map light illu minates for approximately 15
seconds, then it turns off.
While the map light is on, if the ignition switch is
pushed to the ACC or ON position, or if the
driver’s side door is locked, the light turns off.
. When exiting the vehicle
When the ignition switch is pushed to the OFF
or LOCK position, the map lights turn on for
approximately 15 seconds, then it turns off.
If the driver’s side door is locked while the map
lights are on, the light turns off.
NOTE:
It is possible to cancel the key-linked
interior light control system setting. See
the separate Multi Function Display Own-
er’s Manual.
OFF position
When the switch is in the OFF position
*
3
, the
map lights will not illuminate, regardless of any
condition.
Instruments and controls 2-59