Filter
Top Products
10. If the child restraint is installed in the front
passenger seat, place the ignition switch in
the ONposition. The frontpassenger air bag
status light
should illuminate. If this
light is not illuminated see ЉFront passenger
air bag and status lightЉ in this section.
Move the child restraint to another
seating position. Have the system
checked by a NISSAN dealer.
After the child restraint is removed and the seat
belt is fully retracted, the ALR mode (child re-
straint mode) is canceled.
INSTALLING TOP TETHER STRAP
First, secure the child restraint with the LATCH
lower anchors (rear outboardseat positions only)
or the seat belt, as applicable.
1. Flip up the anchor cover
᭺
1
from the anchor
point which is located directly behind the
child seat.
2. Position the top tether strap over the top of
the seatback
᭺
2
.
3. Secure the tether strap to the tether anchor
point on the rear parcel shelf
᭺
3
.
4. Tighten the tether strap according to the
manufacturer’s instructions to remove any
slack.
If you have any questions when installing a
top tether strap, consult your NISSAN
dealer for details.
BOOSTER SEATS
Precautions on booster seats
WARNING
If abooster seat and seatbelt are notused
properly, the risk of a child being injured
in a sudden stop or collision greatly
increases:
– Make sure the shoulder portion of
the belt is away from the child’s face
and neck and the lap portion of the
belt does not cross the stomach.
– Make sure the shoulder belt is not
behind the child or under the child’s
arm.
– A booster seat must only be installed
in a seating position that has a
lap/shoulder belt.
Forward-facing – step 10
WRS0475
LRS0798
Safety—Seats, seat belts and supplemental restraint system 1-31