Nissan 2010 Altima Hybrid Automobile User Manual


 
The front seats are warmed by built-in heaters.
The switches are located on the center console.
1. Start the Hybrid System.
2. Push the LO or HI position of the switch, as
desired. The indicator light in the switch will
illuminate.
The heater is controlled by a thermostat,
automatically turning the heater on and off.
The indicator light will remain on as long as
the switch is on.
3. When the seat is warmed or before you
leave the vehicle, be sure to turn the switch
off.
CAUTION
Do not use the seat heater for extended
periods or when no one is using the
seat.
Do not put anything on the seat which
insulates heat, such as a blanket, cush-
ion, seat cover, etc. Otherwise, the seat
may become overheated.
Do not place anything hard or heavy on
the seat or pierce it with a pin or similar
object. This may result in damageto the
heater.
Any liquid spilled on the heated seat
should be removed immediately with a
dry cloth.
When cleaning the seat, never use
gasoline, benzine, thinner, or any simi-
lar materials.
If any abnormalities are found or the
heated seat does not operate, turn the
switch off and have the system checked
by your NISSAN dealer.
The battery could run down if the seat
heater is operated whilethe Hybrid Sys-
tem is not running.
The power outlets are for powering electrical
accessories such as cellular telephones. They
are rated at 12 volt, 120W (10A) maximum. The
console outlet is powered directly by the vehi-
cle’s battery.
LIC1543
Instrument panel
LIC1070
HEATED SEATS (if so equipped) POWER OUTLET
2-34 Instruments and controls