Filter
Top Products
You can also use the button
to interrupt the system feedback
and give a command at once. See
“List of voice commands” and
“During a call” in this section for
more information.
PHONE/END
While the voice recognition sys-
tem is active, press and hold
the
button for 5 seconds to
quit the voice recognition system
at any time.
TUNING SWITCH
While using the voice recognition
system, tilt the tuning switch up or
down to manually control the
phone system.
GETTING STARTED
The following procedures will help you get
started using the Bluetoothா Hands-Free Phone
System with NISSAN Voice Recognition. For ad-
ditional command options, refer to “List of voice
commands” in this section.
Choosing a language
You can interact with the Bluetoothா Hands-Free
Phone System using English, Spanish or French.
To change the language, perform the following.
1. Press and hold the
button for more
than 5 seconds.
2. The system announces: “Press the
PHONE/SEND (
) button for the
hands-free phone system to enter the
speaker adaptation mode or press the
PHONE/END (
) button to select a dif-
ferent language.”
3. Press the
button.
For information on speaker adaptation, see
“Speaker adaptation (SA)mode”in this sec-
tion.
4. The systemannounces the currentlanguage
and gives you the option to change the lan-
guage to Spanish (in Spanish) or French (in
French). To select the current language,
press the PHONE/SEND (
) button. To
select a different language, tilt the tuning
switch (
or ) up or down.
NOTE:
You must press the
button within 5
seconds to change the language.
5. If you decidenot to change the language,do
not press either button. After5 seconds, the
VR session will end, and the language will
not be changed.
Connecting procedure
NOTE:
The connecting procedure must be per-
formed whenthe vehicle is stationary.If the
vehicle starts movingduring the procedure,
the procedure will be cancelled.
Main Menu
“Connect phone”
᭺
A
“Add phone”
᭺
B
Initiate from handset
᭺
C
Name phone
᭺
D
1. Press the button on the steering
wheel. The system announces the available
commands.
2. Say: “Connect phone”
᭺
A
. The system ac-
knowledges the command and announces
the next set of available commands.
Monitor, climate, audio, phone and voice recognition systems 4-91