Nissan 2010 Altima Hybrid Automobile User Manual


 
The HomeLinkUniversal Transceiver provides a
convenient wayto consolidatethe functionsof up
to three individual hand-held transmitters into
one built-in device.
HomeLinkUniversal Transceiver:
Will operate most Radio Frequency (RF)
devices such as garage doors, gates, home
and office lighting, entry door locks and se-
curity systems.
Is powered by your vehicle’s battery. No
separate batteries are required. If the vehi-
cle’s battery is discharged or is discon-
nected, HomeLink will retain all program-
ming.
Once the HomeLinkUniversal Transceiver
is programmed, retain the original trans-
mitter for future programming procedures
(Example: new vehicle purchases). Upon
sale of the vehicle, the programmed
HomeLink Universal Transceiver buttons
should be erased for securitypurposes. For
additional information refer to “Program-
ming HomeLink” later in this section.
WARNING
Do not use the HomeLink Universal
Transceiver with any garage door
opener that lacks safety stop and re-
verse features as required by federal
safety standards. (These standards be-
came effective for opener models
manufactured after April 1, 1982). A ga-
rage door opener which cannot detect
an object inthe path of aclosing garage
door and then automatically stop and
reverse, does not meet current federal
safety standards. Using a garage door
opener without these features in-
creases the risk of serious injury or
death.
During the programming procedure
your garage door or security gate will
open and close (if the transmitter is
within range). Make sure that people or
objects are clear of the garage door,
gate, etc. that you are programming.
Your vehicle’s Hybrid System should be
turned off while programming the
HomeLinkUniversal Transceiver.
PROGRAMMING HOMELINK
1. To begin, press and hold the two outer
HomeLink buttons (to clear the memory)
until the indicator light
1
blinks (after 20
seconds). Release both buttons.
2. Position theend ofthe hand-held transmitter
1 - 3 inches (26 - 76 mm) away from the
HomeLinksurface.
WIC0986
HOMELINK UNIVERSAL
TRANSCEIVER (if so equipped)
Instruments and controls 2-47