Nissan 2010 Automobile User Manual


  Open as PDF
of 48
 
3
AUTOMATIC DOOR LOCKS
All doors will lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
All doors will unlock automatically when the ignition switch is placed in the OFF position.
The automatic lock and unlock functions can be deactivated or activated independently
of each other. To deactivate or activate the automatic door lock or unlock system, perform the
following procedure:
1. Close all doors.
2. Place the ignition switch in the ON position.
3. Do one of the following within 20 seconds of performing Step #2:
• TochangeAUTOUNLOCKsettings:pushandholdthePowerDoorLockSwitchtothe
position (UNLOCK) for more than 5 seconds.
• TochangeAUTOLOCKsettings:pushandholdthePowerDoorLockSwitchtothe
position (LOCK) for more than 5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator
will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting
change.
SILENCING THE HORN BEEP FEATURE
For vehicles without Navigation system:
To deactivate: Press and hold the
and
buttons for at least 2 seconds.
To activate: Press and hold the
and
buttons for at least 2 seconds.
For vehicles with Navigation system:
If you change the horn beep feature with the keyfob, the display screen will not show the
current mode. Use the keyfob to return to the previous mode and set the horn beep feature
using the control panel.
Press the SETTING button on the control panel.
Select “Comfort & Convenience.”
Press ENTER.
Select “Remote Key Response Horn.”
Set operation conditions to turn horn beep ON or OFF when unlocking the vehicle with the keyfob.
INTELLIGENT KEY BATTERY DISCHARGE
If the battery of the Intelligent Key is almost discharged, the guide
light on the Intelligent Key port blinks and the Intelligent Key
insertion indicator is displayed in the vehicle information display.
To start the engine, insert the Intelligent Key into the key port
in the direction indicated until it latches into place.
To remove the Intelligent Key from the port, push the ignition switch
to turn the engine off and pull the Intelligent Key out of the port.
The Intelligent Key port does not charge the Intelligent Key battery.
If you see the low battery indicator, replace the battery in the Intelligent Key.
 previous next