Filter
Top Products
20
Fold the seatback forward using either the pull
strap
01
located on the outside edge of the rear
seat or the release lever
02
in the cargo area.
To raise the seatback manually, lift up each seatback
and push it to the upright position until it is latched.
To raise the seatback automatically (if so equipped),
push and hold the power seatback switch
03
located in the cargo area or on the lower side of
the instrument panel.
– A beep sounds once and the seatback begins to move
automatically.
– A beep sounds twice when the seatback is fully
returned to the upright seating position.
RECLINING THE REAR SEAT
NOTE: Brace the back of the seat with your arm while pulling on
the strap. The seatback will release quickly.
Pull the reclining strap
01
and move the seatback to the
desired angle.
Release the reclining strap after positioning the seat at the
desired angle.
03
02
HOMELINK
®
UNIVERSAL TRANSCEIVER (if so equipped)
SYSTEM OPERATING TIPS
Garage doors, electrical gates, entry doors, etc., will be activated during programming.
To avoid injury, make sure that people and objects are clear of all doors or gates during
programming. Your vehicle’s engine should be turned off while programming the
HomeLink
®
Transceiver.
To program your HomeLink
®
Transceiver to operate a garage door, gate, entry door opener,
home or office lighting you need to be at the same location as the device.
NOTE: Garage door openers manufactured after 1996 have “rolling code protection.”
To program a garage door opener equipped with “rolling code protection,” you will
need to use a ladder to get to the garage door opener motor in order to access the
“smart” or “learn” program button.