Filter
Top Products
21
PROGRAMMING YOUR HOMELINK
®
UNIVERSAL TRANSCEIVER
(Mirror, Sun Visor or Overhead Console)
1. To begin, press and hold the two
outer HomeLink
®
buttons (to clear
the memory) until the indicator light
blinks slowly (after 20 seconds).
Release both buttons.
2. Position the end of the hand-held
transmitter 1-3 in (26-76 mm) away
from the HomeLink
®
surface.
3. Using both hands, simultaneously
press and hold both the HomeLink
®
button you want to program and the hand-held
transmitter button. DO NOT release the buttons until step 4 has been completed.
4. Hold down both buttons until the indicator light on the HomeLink
®
flashes, changing from a
“slow blink” to a “rapidly flashing blink.” This could take up to 90 seconds. When the indicator
light flashes rapidly, both buttons may be released. The rapidly flashing light indicates
successful programming. To activate the garage door or other programmed device, press
and hold the programmed HomeLink
®
button - releasing when the device begins to activate.
5. If the HomeLink
®
indicator light blinks rapidly for two seconds and then turns solid,
HomeLink
®
has picked up a “rolling code” garage door opener signal. You will need to
proceed with the next steps to train HomeLink
®
to complete the programming, which may
require a ladder and another person for convenience.
6. Press and release the “smart” or “learn” program button located on the garage door opener’s
motor to activate the “training mode.” This button is usually located near the antenna wire that
hangs down from the motor. If the wire originates from under a light lens, you will need to
remove the lens to access the program button.
NOTE: Once you have pressed and released the program button on the garage door
opener’s motor and the “training light” is lit, you have 30 seconds in which to perform
step 7. Use the help of a second person for convenience when performing this step.
7. Within 30 seconds of pressing and releasing the garage door opener program button, firmly
press and release the HomeLink
®
button you’ve just programmed. Press and release the
HomeLink
®
button up to three times to complete the training.
8. Your HomeLink
®
button should now be programmed. To program the remaining HomeLink
®
buttons for additional door or gate openers, follow steps 2-8 only.