33
NAVMAN iCN 620 user manual
To remove the
suction cup, pull the
lever up. Release the
suction
using release tab.
Sucker pad
Suction cup
Lever
Locking nut
Suction or Adhesive Mount to Dash
1 Choose a position on the dash where the iCN 620 will be clearly visible by the driver. Follow the safety guidelines
at the front of this manual to ensure that the unit does not obstruct the view of the driver, or interfere with the
operation of any airbags and safety devices in the vehicle.
2 Make sure that both the dash and the suction cup are thoroughly clean.
3 Suction Mount: if the location you have chosen is at enough, you can simply use the suction cup to mount the
unit directly onto the dash.
4 Adhesive Mount: If the location you have chosen is not suitable to use the suction cup alone, stick the sucker
pad down rst to give a at surface. Do this by removing the protective layer from the adhesive tape on the
underside of the sucker pad, and pressing the sucker pad rmly down for 30 seconds in the desired position on
the dash.
NOTE: this is a permanent solution the adhesive tape and sucker pad cannot be removed from the dash
once xed.
5 Hold the suction cup rmly against the dash or centrally on the sucker pad, and press the lever down until it
snaps shut.
6 The ball foot should now be securely xed. Slip the locking nut loosely over the ball foot, with the at side
facing upwards.
ý