Filter
Top Products
User’s manual NAVIGON 7310
Handsfree Module - 71 -
2. Using your mobile phone, search for other Bluetooth devices.
The navigation device is detected as NAVIGON.
3. Initiate a connection to the detected NAVIGON device.
The mobile phone prompts you to enter a password.
4. Enter a four-digit password (user-defined).
The NAVIGON 7310 prompts you to enter a password.
5. Enter the same password in the Key
box as on the mobile phone
and tap on OK
.
The H
ANDSFREE MODULE window opens. A connection is
established between the two devices. The name of the connected
mobile phone is displayed at the bottom edge of the screen.
9.6.3 Terminating the connection and deleting the connection
data
You can terminate the connection between the NAVIGON 7310 and the
mobile phone at any time.
Note: You don't need to terminate the connection manually. The
connection is terminated automatically when the mobile phone is moved
a distance of approximately10 m from the NAVIGON 7310. In this case
the connection data are saved so that the connection can be restored
automatically when the mobile phone is close enough to the
NAVIGON 7310 again.
1. In the SETTINGS BT window, tap on Connection with Mobile
Phone > Clear Connection Data.
You will be prompted to confirm that you want to terminate the
connection.
2. Tap on the OK
button.
Note: After the connection is terminated, the NAVIGON 7310 is no
longer able to establish an automatic connection to a mobile phone,
including the same mobile phone as for the last connection.
The next connection to a mobile phone must be established manually
(refer to chapter "
4Connection with Mobile Phone" on page 470).