Filter
Top Products
User’s manual NAVIGON 33xx | 43xx max
Navigation - 23 -
Arriving at your destination
When you have reached your selected destination, a message to this
effect will be displayed.
Only your current position (orange arrow) will now be shown on the
map.
6.1 Starting the navigation application
You have switched on the navigation device and, if necessary, entered
the password.
The following message appears:
"The navigation software on this device is designed to provide route
suggestions and does not replace the need for driver attentiveness or
the requirement to adhere to road traffic regulations, good driving
practice and legally posted directions. For safety, posted road signs and
directions should always take precedence over the directions of this
unit. Do not operate this unit while driving."
► After you have read and fully understood the message, tap on OK.
If you do not accept the content of the message, tap on Cancel
in
order to switch the navigation device off again.
The N
AVIGATION window is opened. From here you can access all the
functions of the navigation application.
Only NAVIGON 4350 max:
► Tap on (Phone) in order to move the hands-free module
into the foreground.
► Tap on (Navigation) in order to move the NAVIGATION
window back into the foreground.
For detailed information about the handsfree module refer to the
chapter "Handsfree Module (only NAVIGON 4350 max)" on page 62.
Initialising the GPS receiver
Note: Good reception of GPS data requires an unobstructed path from
the GPS receiver to the satellites. Tunnels, narrow thoroughfares
between buildings and reflecting house fronts can restrict GPS
reception greatly or make it impossible. If the GPS receiver or the
navigation device is inside a vehicle, a metallised windscreen or a
windscreen heater can be the cause of poor GPS reception.
As soon as the navigation device has been switched on, initialisation of
the GPS receiver will begin.