Filter
Top Products
393
Controls in detail
Driving and parking
For more information, see “Driving instruc-
tions” (
୴ page 527).
Turn signals
Combination switch
1 Turn signals, right
2 Turn signals, left
̈ Press the combination switch in the
direction of arrow 1 or 2.
The corresponding turn signal indicator
lamp L or K in the instrument
cluster flashes (
୴ page 28).
The combination switch resets automati-
cally after major steering wheel move-
ments.
Problems while driving
The engine runs erratically and misfires
ț An ignition cable may be damaged.
ț The engine electronics may not be op-
erating properly.
ț Unburned gasoline may have entered
the catalytic converter and damaged it.
̈ Give very little gas.
̈ Have the problem repaired by an au-
thorized Mercedes-Benz Center as
soon as possible.
!
Do not run cold engine at high engine
speeds. Running a cold engine at high engine
speeds may shorten the service life of the en-
gine. This is not covered by the Mercedes-Benz
Limited Warranty.
S 63 AMG and S 65 AMG only:
At engine temperatures below 68°F (20° C), the
maximum speed is restricted in order to protect
the engine. Avoid driving the vehicle at full speed
while the engine is cold in order to prevent pre-
mature engine wear as well as diminished com-
fort.
!
Simultaneously depressing the accelerator
pedal and applying the brakes reduces engine
performance and causes premature brake and
drivetrain wear which is not covered by the
Mercedes-Benz Limited Warranty.
i
To signal minor directional changes such as
changing lanes, press combination switch only
to point of resistance and release. The corre-
sponding turn signals will flash three times.