Filter
Top Products
178
Control systems
COMAND navigation system (entering a destination)
ț “Street”: entering a street
(
୴ page 180)
ț “Center”: entering a center
(
୴ page 183)
ț “POI”: entering a point of interest
(
୴ page 196)
ț “Save”: saving a destination in the des-
tination memory (
୴ page 217)
ț “Start”: starting the route calculation
(
୴ page 190)
̈ Continuing or completing destina-
tion entry: Select one of the menu
items mentioned above.
Entering a town or city
̈ In the address input menu, select
“Town”.
The list of towns/cities appears either
with or without the input characters
(
୴ page 179).
Whether or not the input characters ap-
pear depends on how many towns or
cities are available for the desired state
(USA) or province (CDN).
List of towns or cities with input
characters
When this list appears, the input charac-
ters 4 are automatically activated.
1 Top list entry based on the input data
up to that point
2 Characters entered by the user
3 Characters automatically added by the
system
4 Input characters
5 Currently non-selectable characters
6 Currently selectable character
7 List of towns/cities
8 Currently selected character
i
In this case, entering a POI is based on the
town or city seen in the address input menu.
i
You can only enter those towns or cities
which are saved on the digital map.
It is not possible to enter a town or city when you
have already entered a street which COMAND
can clearly attribute to a town or city.
If COMAND cannot clearly attribute a previously
entered street to a town/city, only those towns
or cities are available which have a street of that
name.
If you have not yet entered a street before enter-
ing the town or city, towns or cities within the
state (USA) or province (CDN) previously en-
tered are available.