Filter
Top Products
387
Controls in detail
Power windows
Vehicles with SmartKey
̈ Aim transmitter eye of the SmartKey
towards the sensor in the driver’s door
handle. The SmartKey must be in close
proximity to the driver’s door handle.
Vehicles with tilt/sliding sunroof
̈ Press and hold button ‹ until the
door windows and the tilt/sliding sun-
roof are completely closed.
̈ Release button ‹ to interrupt pro-
cedure.
Vehicles with panorama roof* and/or
rear side window sunshades*
̈ Press and hold button ‹ until the
door windows and the tilt/sliding panel
are completely closed.
̈ Press and hold button ‹ again.
The roller sunblinds and/or rear side
window sunshades* close.
̈ Release button ‹ to interrupt pro-
cedure.
Warning! G
When closing the windows and the tilt/slid-
ing sunroof or tilt/sliding panel*, make sure
that there is no danger of anyone being
harmed by the closing procedure.
If potential danger exists, proceed as fol-
lows:
ț Release button ‹ to stop the closing
procedure. To open, press and hold but-
ton Œ. To continue the closing after
making sure that there is no danger of
anyone being harmed by the closing pro-
cedure, press and hold button ‹.
Vehicles with KEYLESS-GO*:
ț Release the sensor surface on the out-
side door handle (
୴ page 388) to stop
the closing procedure.
ț Immediately pull on the same outside
door handle and hold firmly. The door
windows and the tilt/sliding sunroof or
tilt/sliding panel* will open for as long
as the outside door handle is held but
the door is not opened.
i
If you press ‹ while one of the front door
windows is open and one of the rear door win-
dows is closed, for example, then the front side
window and the rear side window sunshade will
be closed. To prevent this from happening, first
open all door windows slightly by briefly
pressing Πand then close all door windows
by pressing ‹.