Filter
Top Products
301
Control systems
Voice Control* navigation
“Navigate to <voice entry>” (address
book)
Use the command “Navigate to <voice en-
try>” to start route guidance by selecting
voice entry with a saved destination ad-
dress from the COMAND address book.
A voice entry may have two different desti-
nation addresses associated with it (home
or work).
The system confirms your command, cal-
culates the route, and begins route guid-
ance.
If only one address is stored, you can use
the command “Navigate <voice name>” to
select the stored destination address for
that name.
If two addresses are stored, you can use
the commands
ț “Navigate <voice name> home”
or
ț “Navigate <voice name> work”
to directly select between home or work
address for that name. The system con-
firms your selection, calculates the route,
and begins route guidance.
Sample dialog:
s Navigate to John Smith
If more than one address exists for
this voice entry, the Voice Control
System will prompt you:
t Navigate to home or work?
s Work
t John Smith work
Starting route guidance
“Start route guidance”
Use the command “Start route guidance”
to start route guidance after entering a val-
id destination.
Sample dialog:
s Start route guidance
t Starting route guidance
Route guidance begins.
“Guidance instructions on”
Use the command “Guidance instructions
on” to have the Voice Control System re-
peat the last guidance instruction. If guid-
ance voice output was previously muted,
using this command will deactivate the
muting of the voice output.
“Guidance instructions off”
Use the command “Guidance instructions
off” to mute the systems’ guidance voice
output.