Filter
Top Products
65
Safety and Security
Occupant safety
Head restraints must be positioned such
that the top tether strap can pass freely
between the head restraint and top of seat
back.
̈ Make sure the tether strap is not twist-
ed.
2 Hook
3 Anchorage ring
̈ Securely fasten hook 2, which is part
of the tether strap, to anchorage
ring 3.
Once the top tether anchorage hook is at-
tached, the child restraint itself can be se-
cured. Tighten the top tether strap
according to the child restraint manufac-
turer’s instructions.
̈ Reinstall cover after removing the
tether strap.
Child seat anchors – LATCH type
This vehicle is equipped with two LATCH
(L
ower Anchors and Tethers for CHildren)
type anchors (at each of the rear seats) for
the installation of a LATCH child seat with
the matching anchor fittings.
If you have not installed a child seat, the
LATCH anchor are covered with an uphol-
stery blend.
1 Indicates the position of the anchors
2 Anchors
3 Upholstery blend
4 Installation device
i
For safety reasons, make sure hook 2 has
attached to ring 3 beyond the safety catch, as
illustrated.
Warning! G
Vehicles with adjustable rear seats/bench*:
Never adjust the rear seat position after in-
stalling the child restraint. Adjusting the rear
seat position after installing the child re-
straint could damage the child restraint
and/or introduce undesirable slack or ten-
sion into the seat belt and loosen or mispo-
sition the child restraint, lessening the
effectiveness of the child restraint and thus
increasing the chance or severity of injury in
an accident.
୴୴